front brake pads

[BlasterEaten250]

It's been a while since I replaced the pads and I can't remember if the hub is supposed to spin freely after you do it. I put the new ones on and the hub is very hard to spin. Do they just have to be broken in or did I miss something? It wasn't that hard to slide the caliper with fresh pads onto the rotor..

[BlasterEaten250]

When I tighten the caliper to the spindle it makes the inside brake pad loose but it pulls the outside one tight to the disk. Does this mean something is bent?

[BlasterEaten250]

picture. The other side is fine btw

[gcart2]

make sure both sides are bled. no air in either line. you will be okay.

[Brauap]

thats normal. Thats how mine where.. they just need to be broken in.. don't worry about it.

[BlasterEaten250]

Thanks for the suggestions but i figured it out the two slider bolt things had to be greased.