PDA

View Full Version : stock wheel sizes


sheriff525
12-08-2008, 01:18 PM
What are the stock wheel sizes front and back of the 07 outlaw irs. I need also bolt patern and off sets too.

What do i need for an offset if i want my dune tires a few inches wider than stock. i don't understand offsets
scuzz
12-08-2008, 01:47 PM
Call Rocky Mountain ATV up, they have the size listed as 10" x 8.5 in the rear.

Here's their phone number:

1 800 336-5437 7am–7pm Mon–Fri, 8am–4pm Sat MST

Showroom Hours: 8am–7pm Mon–Fri, 8am–4pm Sat MST
OutlawBill
12-08-2008, 01:48 PM
fronts 10x5 3x2 offset 3 inches in 2 out 5 wide 4x156 bolt pattern(Yamaha) rear 9x8 offset Approx 6.5 X1.5 inches bolt pattern 4X110 (Honda). to go wider cheaper to get wheel spacers than custom wheel my DWT black label 10x9 cost me about $150 each and took 45 days to get.
scuzz
12-08-2008, 01:56 PM
I <3 Bill.
GE4x4
12-08-2008, 02:09 PM
Or you can get a set of Pred rear rims, flip them so the off-set is 5" inside and 3" outside. Take the valve stem and flip it so the stem goes on the inside. Then drill a hole on the other side and put on a new valve stem. This should get you around 50" in the rear.:D
xtreme 250x
12-08-2008, 03:48 PM
very inventive:D
sheriff525
12-08-2008, 04:41 PM
so could i just get honda 10" rims for the back and yamaha for the front?
GE4x4
12-08-2008, 05:27 PM
Originally posted by sheriff525
so could i just get honda 10" rims for the back and yamaha for the front?

This would work.
With the 10" rear wheel you might not need to move the valve stem as there will be more clearence.
SSJEFF
12-09-2008, 01:43 AM
"Or you can get a set of Pred rear rims, flip them so the off-set is 5" inside and 3" outside. Take the valve stem and flip it so the stem goes on the inside. Then drill a hole on the other side and put on a new valve stem. This should get you around 50" in the rear."

This will not work due to the inner bell. I have tried it.
sheriff525
12-12-2008, 11:29 PM
What does these numbers mean anyways.


20x10x9

I take it 20 is the hight of the tire.
and the 9 is the rim size..

What is the 10 ....the width?

So will a 20x11x9 work on my irs?
U1arunit
12-13-2008, 06:37 AM
Originally posted by sheriff525
What does these numbers mean anyways.


20x10x9

I take it 20 is the hight of the tire.
and the 9 is the rim size..

What is the 10 ....the width?

So will a 20x11x9 work on my irs?

Yes, 10" is the tire section width.

And.. Yes 20x11-9 will work. I just installed RAZR's in that size on my '08 IRS.