Roller Bearings

[chayes627]

ill be putting bearings in the carrier when i get my new axle and im looking into replacing the front bearings too, are these going to be anybetter/last longer than stock?

http://cgi.ebay.com/ebaymotors/UPGRADE-FRONT-WHEEL-BEARINGS-SEALS-HONDA-TRX450R-450R_W0QQcmdZViewItemQQ_trkparmsZ66Q3a4Q7c65Q3a1Q7 c39Q3a1Q7c240Q3a1318QQ_trksidZp3286Q2ec0Q2em14QQha shZitem250310417441QQitemZ250310417441QQptZMotorsQ 5fATVQ5fPartsQ5fAccessories

[kbass24emtp]

Yes they should. Tapered bearings are able to take a much greater side load than normal ball bearing. I have Hardkor Engineering front hubs with tapered bearing on my R. I've had them for two years now with no problems. If this kit was around when I bought the hubs I would have gone with the conversion kit instead of the hubs.

[REPOMAN]

i bought a set from that guy and they are good.

[chayes627]

ok thats kool. they look decent and ill proli get a set from him later. also im proli gonna get all balls carrier bearings and there any other alternatives that are better without getting a billet carrier