st8jacket
11-10-2008, 11:01 PM
Were gonna try to lower my nephews 250r/cr80 hybrid tommorow..Past 2 races he's bicycled it up on two wheels in a corner..He's been hooking his leg and dam neer comming off the quad leaning in to the turn how he should..
The run down of the quad is..
stock frame
janssen outlaw2 a-arms
fox float evol dcs
janssen stock length swinger
axis dual rate valved for rider
rider weighs 120 lgs..
the ride hight now is about 8'' towards the center of frame,and the a-arms still set a lil angled down while he's on the quad..I wanna try to get his ride hight down about 2-3 inches if possible..
For the rear should we raise the preload collars a bit and lower the main spring cross over hight?and possibly bump up the compression on the ressy?
for the front floats were kinda shooting in the dark,as we never messed with that type of shock before..Ive read the book front to back 4 times and im still lost..
sorry for the long post..But thanks in advance..
The run down of the quad is..
stock frame
janssen outlaw2 a-arms
fox float evol dcs
janssen stock length swinger
axis dual rate valved for rider
rider weighs 120 lgs..
the ride hight now is about 8'' towards the center of frame,and the a-arms still set a lil angled down while he's on the quad..I wanna try to get his ride hight down about 2-3 inches if possible..
For the rear should we raise the preload collars a bit and lower the main spring cross over hight?and possibly bump up the compression on the ressy?
for the front floats were kinda shooting in the dark,as we never messed with that type of shock before..Ive read the book front to back 4 times and im still lost..
sorry for the long post..But thanks in advance..