400exrider_88
10-27-2008, 10:35 AM
i just put new cometic gaskets in the topend
for the gasket that goes between the cylinder and head, 3 valve cover bolts would not go through, so i used a sharp punch and hammer to make holes to get the bolts through.
why would this ruin the entire seal
would they make a gasket that not all the bolts go through?
can it leak from the exhaust?
it looks like oil is coming out of the exhaust
also, when i bought the 400, it was jetted for a trinity stage Iv pipe. do i have to change it for the stock pipe?
with an 11:1 piston can i run the stock pipe? it didnt run good
for the gasket that goes between the cylinder and head, 3 valve cover bolts would not go through, so i used a sharp punch and hammer to make holes to get the bolts through.
why would this ruin the entire seal
would they make a gasket that not all the bolts go through?
can it leak from the exhaust?
it looks like oil is coming out of the exhaust
also, when i bought the 400, it was jetted for a trinity stage Iv pipe. do i have to change it for the stock pipe?
with an 11:1 piston can i run the stock pipe? it didnt run good