Shifter input shaft

[troybilt]

Rounded the splines yesterday, so how screwed am I?

Also measured compression 135-140 lbs, is it time for a new top end?

[C-LEIGH RACING]

Originally posted by troybilt
Rounded the splines yesterday, so how screwed am I?

Also measured compression 135-140 lbs, is it time for a new top end?


I would say not bad at all, just a matter of pulling the clutch cover & the clutch, pull out the old messed up shift shaft, put in the new one, put it all back together, then, pull the top end & have the next size piston fitted in your cylinder. Probably somewhere around 300.00 you could be rolling again.
Wiseco pistons have gone WAY up in price & you can hardly find a Pro-x cast anymore. Might be a few sizes here & there but Pro-x is about gone.
Neil