Lonestar DC4 A arms NEW

[hontrx265r]

I have forsale a set of lonestar dc4 longtravel a arms forsale. These are brand new, never used. I bolted them on my bike to roll it around while I was powdercoating my other setup. When I say new I mean new. Ball joints heims, bushing everything is new I didn't even grease them because they were not used at all. They are straight from the factory and I had them powdered with clear to give it a factory look, they look awesome in the sun with the welds. No tierods these are +4+0 they will make your bike 50in on the dot with 4+1's 500.00 obo. they retail for over 800.00

[hontrx265r]

pic2

[hontrx265r]

pic3

[hontrx265r]

This pic shows a swingarm that I bought with the arms and also had cleared, gives you an idea of what they look like in the light. Only reason I'm selling is because I have 2 sets.

[250Renvy]

What length shock do these use? What frame are they for?

[hontrx265r]

They use 19 or 19.25, Really depends on your set up, I think you can acutally use all the way down to 18.5. They are 250r geometry

[jrspawn]

Whats the measurement from center of pivots to center of balljoints on the uppers and lowers?

Thank you
Justin

[hontrx265r]

Thats kind of an odd question, because it depends on where the balljoints are adj. too. I'm 100% sure they are +4+0 if thats what your concerned about they would also fit a narrow frame as +3's I have ls +3+1 also for another bike so its obvious the difference. And I live in phoenix so I got them right at lonestar.

[jrspawn]

If you could, please still cheack the measurement for me with the way they are set. Or run the balljoints in and measure please. Im needing another set of +4's and just want to be positive they will be the right length for me.

Thank you
Justin

[hontrx265r]

If its set up right you wouldn't bring the balljoints in much more there are only a couple threads up top the lowers could be brought in slightly. They are 18" center to center. lowers, uppers are about 15"
Thanks
Mike