Tricky Problem

[hetrick_racing9]

I have a roll design swingarm with a rpm axle.. when i ride the read end is always sliding around and in mud is pretty much impossible to keep straight in the corners..

possible problems i think it might be

swingarm bears
carrier

i know its not the tires they are razr sticky's

and my front end appears to be fine although on wheel spins slow.. which i am fixing but i dont figure would be the cause of my rear end sliding sideways when giving it off jumps and such..

please help me its a big problem ..

if anyone else has had this issue or has any other ides of things to check PLEASEEEEE HELP ME haha thanks

Bunyan Racing # 14

[Blue250X]

Just go out and move your rear end around a little bit, put it on a jack and grab the swinger and move it side to side, same with the axle. If those are tight, try the hubs. If all else fails, if you have an extended swingarm, it could be keeping you from getting the power to the ground and it could be just all going up in spinning.
Hopefully that helps.

[hondaking52]

i would just jack the frame off the ground and start shakeing things, might be ur swinger bearings, might be ur carrier bearings, or ur axle might be loose.....