Maximum Bar Height? 3 part question

[ravage3000]

1.
Looking for the maximum bar height for the 450R. Will be going with the fatbar mx style bars (Trail Tech or Pro Taper Contour). So what is the maximum height for all the cables and wires without binding anything?

2.
Pro Taper Contour ATV bars.. is there enough room at the ends to mount everything including handguards?

3.
Is there any 7/8 bars that have enough room at the ends to mount everything without perches being mounted where the bars begin to bend? MX style bend, no wider then 805mm if possible.

Help will be greatly appreciated and if pictures are possible that would be great help too!

Thanks

[chadbarger18]

I have the contor atv high bars and there is enough room for the stock swiches power madd hand throttle clutch and brakes on the ends and all of the cables are long enough but i havent had any experience with the other bars

[bluebaron]

Whats going to really limit you on height is the stock brake line.

[ravage3000]

That's what i'm asking. The tallest bar or bar riser for the stock cables, wires, brake line. So let me re-phrase it.. How much taller can I go from stock. 1 inch? 2inches taller?

[bluebaron]

I have all the stock cables, and I have 50mm risers with, Tag T2s, the bars are a little lower than stock. The brake line was pretty tight, so I unbolted the little clamp right before the line comes out of the plastic so It gives it a little more play.

[ravage3000]

What bend T2's? Do you have any pictures of this?

[bluebaron]

The T2s are a "Fourtrax" bend, I had them on my old quad a few years ago, I haven't seen anywhere offer that bend since, I'm sure there just like cr high or something that just say fourtrax, but not positive. No I don't have any pictures