atvmaster0927
08-25-2008, 04:27 PM
Today i went to see if i had a Temp Light under the hood. And i did, but it did NOT have the plastic red piece thing on it.
So i wanted to see if the light was working. So i disconnected the ECT sensor and started the engine. The light never came on.
So i went to see if thethe black and red wires from the ignition were spliced together.(Because i run no key). And i found a connector (wasnt plugged in) and it had all four of the correct wires..(so i assumedthose were the wires for it)...then i spliced the red and black wire together and started it again and nothing happend. So i guess that wasnt the correct wire. I'm not sure.
Maybe i need a new temp light sensor?
I wanna install my fan but i have to do this first..i think. Also i plugged the fan in and nothing happened either. I put the blue connector on the fan into the only slot it would fit and that didnt come on either.
Also i started to trace where my killswitch went and it started going toward the cdi inthose wires. So i dont know whats up with that
Here's a picture of the wirs i thought it was...
1. I circled where i spliced.
2. I made X's on the two wires i cut them from.
3. I made a small circle on the green wire that was still connected.
So i wanted to see if the light was working. So i disconnected the ECT sensor and started the engine. The light never came on.
So i went to see if thethe black and red wires from the ignition were spliced together.(Because i run no key). And i found a connector (wasnt plugged in) and it had all four of the correct wires..(so i assumedthose were the wires for it)...then i spliced the red and black wire together and started it again and nothing happend. So i guess that wasnt the correct wire. I'm not sure.
Maybe i need a new temp light sensor?
I wanna install my fan but i have to do this first..i think. Also i plugged the fan in and nothing happened either. I put the blue connector on the fan into the only slot it would fit and that didnt come on either.
Also i started to trace where my killswitch went and it started going toward the cdi inthose wires. So i dont know whats up with that
Here's a picture of the wirs i thought it was...
1. I circled where i spliced.
2. I made X's on the two wires i cut them from.
3. I made a small circle on the green wire that was still connected.