DanW
08-22-2008, 04:14 PM
2006 Motor with HRC kit/starter/sprocket - $1500
2006 MN DNR registered Frame that's not bent or welded on - $750
Rath +1 stem that's been lowered about ¼" to help with bump steer - $150
Stock front shocks - $200
Swingarm/bearing carrier/axle/brake hub - $300 - includes swingarm bolt, swingarm skid that's modded for ground clearance, chain, good 37 tooth rear sprocket, wheel hubs and stock linkage.
Brake set - $250 - front calipers, rotors, master cylinder w/lever & lines (didn't open so doesn't need bleeding - bolt on and go), rear caliper, master cylinder & lever (didn't open, bolt on & go). No rear rotor included.
Stock a-arms/hubs/spindles - $100
Radiator w/fan - $100 - includes fan, over flow tank & hoses.
Wiring harness with cdi - $50
Rath nerfbars with BIG stainless steel pegs built in. The nets are partially cut away (for backing up) and the nerfs are dinged up from rubbing against trees, but they still work very well. These are the best foot pegs that I've ever used! $100.
Seat - Could use a cover but still useable - $50.
Rath grab bar/rear fender mount - scratched up but straight - $50.
Head light/tail light - $75.
2006 MN DNR registered Frame that's not bent or welded on - $750
Rath +1 stem that's been lowered about ¼" to help with bump steer - $150
Stock front shocks - $200
Swingarm/bearing carrier/axle/brake hub - $300 - includes swingarm bolt, swingarm skid that's modded for ground clearance, chain, good 37 tooth rear sprocket, wheel hubs and stock linkage.
Brake set - $250 - front calipers, rotors, master cylinder w/lever & lines (didn't open so doesn't need bleeding - bolt on and go), rear caliper, master cylinder & lever (didn't open, bolt on & go). No rear rotor included.
Stock a-arms/hubs/spindles - $100
Radiator w/fan - $100 - includes fan, over flow tank & hoses.
Wiring harness with cdi - $50
Rath nerfbars with BIG stainless steel pegs built in. The nets are partially cut away (for backing up) and the nerfs are dinged up from rubbing against trees, but they still work very well. These are the best foot pegs that I've ever used! $100.
Seat - Could use a cover but still useable - $50.
Rath grab bar/rear fender mount - scratched up but straight - $50.
Head light/tail light - $75.