Help Please Asap!!!!

[RaginRedneck]

I'm trying to install a kill switch, the kind with a tether so if I launch my dumb arse off my bike I have a decent chance of eventually catching up with it.

So I bought a Pro Design Kill Switch. It has two wires, one is ground and the other it says to:

"Connect the long wire of the kill switch to the pulse trigger lead from the stator assembly."

In the picture it identifies the pulse trigger/pulse coil. In my Honda book I'm guessing this is the CKP Sensor?? If it is, where the hell is that at?


Can I just connect this wire to the wire that goes to the factory kill switch??

Please help!!

Thanks!

[shallow518]

just splice into the wire that comes from the kill switch, i went to the black with a white tracer.

[RaginRedneck]

Awesome, thanks.

I just got done reading an article that said to splice it to the Black/Yellow Tracer that comes out of the ICM, but if the kill switch wire works, I may just do that.

thanks for the help.