RaginRedneck
08-13-2008, 07:49 PM
I'm trying to install a kill switch, the kind with a tether so if I launch my dumb arse off my bike I have a decent chance of eventually catching up with it.
So I bought a Pro Design Kill Switch. It has two wires, one is ground and the other it says to:
"Connect the long wire of the kill switch to the pulse trigger lead from the stator assembly."
In the picture it identifies the pulse trigger/pulse coil. In my Honda book I'm guessing this is the CKP Sensor?? If it is, where the hell is that at?
Can I just connect this wire to the wire that goes to the factory kill switch??
Please help!!
Thanks!
So I bought a Pro Design Kill Switch. It has two wires, one is ground and the other it says to:
"Connect the long wire of the kill switch to the pulse trigger lead from the stator assembly."
In the picture it identifies the pulse trigger/pulse coil. In my Honda book I'm guessing this is the CKP Sensor?? If it is, where the hell is that at?
Can I just connect this wire to the wire that goes to the factory kill switch??
Please help!!
Thanks!