250x_kyle
08-10-2008, 09:01 AM
i have an 02 400ex yz 400f hybrid im thinking about parting out. plus i have quite a few spare 00 400ex chassis parts
aftermarkets:
itp bajas
powermadd hand guards 40 shipped
g force axle
rad axle carrier
tusk nerfs
msr aof clutch perch and lever 17 shipped
tc shorty slip on(will work on stock 400 gotta cut the header down a bit.) PENDING
uni filter
dyno jet jet kit for 400ex 25 shipped
250r dg grab bar. 25 shipped
yz400f motor. bored, mild port and polish, kibble white valves and valve springs, yz450f decompressoin cam kick start extention kicker knuckle and lever plus a header. 1200 shipped
stock:
400ex carb 50 shipped
2 front calipers 90 shipped
1 rear caliper w/master cyclinder (tusk parking break block off) 90 shipped
2 swingarms one powdercoated stealth black with bearings.
1 400ex frame
1 axle PENDING
1 set of spindles 90 shipped
aarms with tie rods Pending localy
3 rear hubs 55 shipped 1 set or 25 each
2 front hubs 60 shipped
2 stock stems 1 PENDING
2 sets of stock bend bars 20 shipped
2 rear shocks 55 shipped each
2 linkage 15 each
2 brake stays 15 each
1 lock nut 10 shipped
400ex oil tank 30 shipped.
400ex sub frame (needs battery tabs moddified for grab bar) make offer
http://i46.photobucket.com/albums/f134/needanewquad/DSCF0350.jpg
http://i46.photobucket.com/albums/f134/needanewquad/DSCF0352.jpg
http://i46.photobucket.com/albums/f134/needanewquad/DSCF0328.jpg
aftermarkets:
itp bajas
powermadd hand guards 40 shipped
g force axle
rad axle carrier
tusk nerfs
msr aof clutch perch and lever 17 shipped
tc shorty slip on(will work on stock 400 gotta cut the header down a bit.) PENDING
uni filter
dyno jet jet kit for 400ex 25 shipped
250r dg grab bar. 25 shipped
yz400f motor. bored, mild port and polish, kibble white valves and valve springs, yz450f decompressoin cam kick start extention kicker knuckle and lever plus a header. 1200 shipped
stock:
400ex carb 50 shipped
2 front calipers 90 shipped
1 rear caliper w/master cyclinder (tusk parking break block off) 90 shipped
2 swingarms one powdercoated stealth black with bearings.
1 400ex frame
1 axle PENDING
1 set of spindles 90 shipped
aarms with tie rods Pending localy
3 rear hubs 55 shipped 1 set or 25 each
2 front hubs 60 shipped
2 stock stems 1 PENDING
2 sets of stock bend bars 20 shipped
2 rear shocks 55 shipped each
2 linkage 15 each
2 brake stays 15 each
1 lock nut 10 shipped
400ex oil tank 30 shipped.
400ex sub frame (needs battery tabs moddified for grab bar) make offer
http://i46.photobucket.com/albums/f134/needanewquad/DSCF0350.jpg
http://i46.photobucket.com/albums/f134/needanewquad/DSCF0352.jpg
http://i46.photobucket.com/albums/f134/needanewquad/DSCF0328.jpg