how 2 put 300ex in time

[jenkins31]

how hard is it 2 put the 300ex in time after u change the rings

[300exboy #15]

its not hard at all all u have 2 do is line verything up if u have a service manual

[jenkins31]

k wel i need 2 get one of thoses b/c i think that im goin 2 bebuild mine and i believe that i will need one of theses

[GRASSHOPPER71]

ON THE CAM IS THREE SMALL LINES ON THE SPROCKET. TWO OF THE LINES ARE STRAIGHT ACROSS FROM EACH OTHER AND ONE IN BETWEEN THOSE TWO. THE TWO LINES THAT ARE STRAIGHT ACROSS FROM EACH OTHER,, LINE THOSE UP EVEN WITH THE SUFACE OF THE HEAD AND THE OTHER LINE SHOULD BE POINTING STRAIGHT UP. MAKE SURE THE LOBES ON THE CAM SHAFT ARE DOWN.
ON THE LEFT SIDE OF THE ENGINE ON THE FLYWHEEL COVER THERE ARE TWO SCREWS THAT YOU WILL NEED A BIG FLAT-HEAD SREWDRIVER TO REMOVE. ONE HOLE IN THE CENTER IS TO TURN THE FLYWHEELL AND THE OTHER IS THE HOLE FOR THE TIMEIN MARK. ON THE FLYWHEEL THERE ARE TWO MAKES,, ONE HAS A T BY THE MARK AND THE OTHER HAS A F BY IT.
LINE UP THE T MARK WITH THE SLOT IN THE SMALL HOLE.. AND PUT THE CHAIN ON.