how easy is it 2 send out your cylinder2 get studs?

[speedfoxracing]

if i send cylinder 2 gt thunder are they quick or do u all recomend someone else? and i planin on byin a big bore kit with cylinder so i,ll just send it there when i get it

[hillbilly426]

very fast 5 days i had mine back . they do awesome work

[hypersnyper6947]

Yes they are quick and awesome, they do a great job they did my re-sleeving also. Also you can check your status on there website.

[Honda5]

get the tap and do it yourself. i have done several it's easy.

[speedfoxracing]

Originally posted by Honda5
get the tap and do it yourself. i have done several it's easy.

but it say you should re hone the clyinder after? do u do that or no cause i allready have the tap and know i could do it my self

[leasureryan]

you have to hone due to it will egg out your cylinder.....so you have to make it round again

[Honda5]

I always run new rings and run a hone through it but a hone will not fix a egged cyl. where did you read that? I want to learn as much as I can but I have never heard of that. I am going to go out and check the couple of 440 and426 cyl that I studded to see if there are out of round.

[speedfoxracing]

see i,m buyin a kit with cylinder and once i get it i,m just prob goin 2 send it out then or should i do it since u have 2 have them at a sertine height?

[Honda5]

the stud height are in the tech book.

[speedfoxracing]

the stud height is also on gt thunders webpage but idk wut i,m doing yet weather i want 2 do 440 or go all out with a yz or wr motor or just bore mine 2 a 416