A-Arm Brake line clamps for LSR Arms

[mooseracerX]

Looking for some aluminum brake line clamps to hold the stainless lines onto the top a-arms of Lone star Racing arms. Not looking to spend too much.

[badzboy11]

I have a set that will fit 1" a-arms. $10 shipped
http://i241.photobucket.com/albums/ff166/badzboy11/400exparts015.jpg

[mooseracerX]

I might take them. I'll go and measure my a-arms with a caliper later.

[mooseracerX]

I'm not sure. The size on the caliper was .776 or so. They probably won't fit. What kind of a-arms did they come off of?

[badzboy11]

I had them on Action a-arms aftermarket. Sounds like yours are 3/4"

[mooseracerX]

Oh yeah duh where are my math skillz. haha I don't know of a way I could make them fit. Sucks because the price is right.

[billyboy]

you can install a thin peice of rubber between the arm and the clamp to make it fit and that way it does not tear the finish up on the a-arm either.

The set I have cam with the rubbers in them.

[badzboy11]

The rubber trick will work but I do not have rubber in mine.

[billyboy]

Originally posted by badzboy11
The rubber trick will work but I do not have rubber in mine.


Understandable.. I was just throwing a suggestion out there. That is a pretty good deal on brake line clamps. Kind of hard to pass up.

[mooseracerX]

I'll think I'll take them. I was thinking of buying a rubber hose and putting it over the a-arm and then putting the clamp on. My dad's a genius when it comes to stuff like that I'm sure we can figure something out. You wanna PM me your Pay pal addy and I'll get the money right out.

[badzboy11]

Originally posted by mooseracerX
I'll think I'll take them. I was thinking of buying a rubber hose and putting it over the a-arm and then putting the clamp on. My dad's a genius when it comes to stuff like that I'm sure we can figure something out. You wanna PM me your Pay pal addy and I'll get the money right out.

Sent pm