steering stem

[bets400ex]

Whats the best way to straighten the stem after being rolled or am i better off getting a new one?

[k4f5x0r]

way better off getting a new better one because i bent the stock one on our old 300 and didnt replace it and its hard as hell to turn compared to my kfx.

[esr250r86]

I used a pipe bender...like a manual hydraulic jack one.but id buy a new one if its bent pretty bad because I bent mine back and then wrecked it again at a race and it just snapped my stem in half.lol.so be careful if you bend it back because its going to be weaker now.

[bets400ex]

Thanks for all the advice fellas

[big95xj]

I bent mine back to were it was hitting the gas tank and we just heated it and bent it back...seemed to work fine so far...

[07HRC450R]

ur better off getting a new one...i bent mine about a month and a half ago and bought a new +1 for only $199.95!!!! heres the website...www.superatv.com

[TJ240z]

Can anyone else shed some light on stearing stems? i currently have one that was made for me and i got it cheap. Lasted for 3 years but finally destroyed it. im looking for a cheap replacement that will use the stock clamps.