John451
06-21-2008, 08:38 PM
I just took my blaster engine apart to replace the crank seals. I had to take the clutch out and off. Now that its back together it runs great but the clutch wont engage. When i took it apart I took all the clutch parts off. Like basket and all. The pressure plate came off with the bar in the middle. There is supposed to be a ball in the middle of the shaft. Idk if that fell out if that would make the clutch not work. The other bar is still in there. But it doesnt make sense to me for it to be that because the clutch wont engage fully and if the ball wasnt there the plates would be pushed together and the clutchh would work. Did i tighten the springs too much? When i turn the lever at the engine theres no friction. There's alot of slack in the clutch cable too. Can the ball just fall out like that? Would it cause that? Would a .177 bb fit in there? Could it be because i tightened the clutch spring bolts too much? Thanks in advance. Any help will be greatly appreciated.
The ball is number 21 in the picture below.
The ball is number 21 in the picture below.