PDA

View Full Version : Esr370 Complete Motor


doc-bones
06-21-2008, 07:45 AM
This motor started out as a ESR350 with 5 mil stroke which makes it a 370. Sent to K&T to make it an animal. Just Built 0 hours since rebuilding. This motor is fresh ready to rip someones arms off!!!
Will DESTROY any 4 strokes!!
New Bearings and seals throughout!
New Crank Bearings
New water pump and seals
New piston and Rings
Billet Head with race dome
Hinson Basket
Hinson Pressure plate
Stock Clutch plates
CR500 Springs
Hinson Quick Change cover with fresh Black powder Red Billet Cover
Black powder ignition cover
NEW Left case
Transmission completely inspected... Any worn items replaced!!
Lectron Carb made for this motor
I have a lot of money invested into this motor and it has 0 hours.
$2600. + shipping

REDUCED for quick sale................$1,875. shipped with quick change cover................$1,750. shipped without clutch cover!!
FIRM......FIRM......FIRM.....
THIS IS A STEAL!!!!!!!!!!!!!!!!!!
doc-bones
06-21-2008, 07:46 AM
pic
kubitza123
06-27-2008, 07:18 PM
what kinda hp do you think it would dyno at? I know a guy with a complete 250r forsale with a complete esr 370 kits pipe topened etc everything and he said it dyno'ed at 64 hp at the rear wheels. Also do these motors hold up good? I would just be using it for play not hardcore racing etc
doc-bones
06-29-2008, 09:02 AM
This motor was done by K&T which produce a lot of HP. They are reliable as long as you run good gas and oil and change piston and rings when needed. 64Hp sounds right for most 370`s. This one will be over 70 HP.
doc-bones
07-04-2008, 07:57 PM
$2350.00 without quick change clutch cover! This is a steal considering all the cash spent building this monster! All 100% new/rebuilt!!!
doc-bones
07-07-2008, 06:55 PM
Minus Hinson clutch set-up and Hinson clutch cover $2,000. shipped!
doc-bones
07-29-2008, 06:01 PM
This is absolute lowest price! Someone should take advantage of this deal quickly! 5K in this motor! Will accept paypal just add 3% to total to cover their fees!
Thanks,
Docbones
doc-bones
08-15-2008, 09:08 AM
No way you will find a better Motor at this price!
800screws
08-15-2008, 03:11 PM
doc, what's the porting on the engine?
doc-bones
08-15-2008, 10:25 PM
mid to top although plenty of bottom end
doc-bones
08-20-2008, 06:39 PM
SOLD-Pending Funds!
doc-bones
08-24-2008, 08:31 AM
Looks like this motor may still be available. No funds recieved!
doc-bones
08-25-2008, 06:57 AM
You missed out on a beast R motor.........SOLD!!!!!!!!!!!