PDA

View Full Version : 16 tooth sprocket


drew416ex
06-17-2008, 08:50 PM
Hey I was just curious if a 16tooth front sprocket would fit with no problems. Thanks!
REDRIDDER
06-17-2008, 09:04 PM
it fits but you cant use your case saver with the 16 tooth on.
NacsMXer
06-17-2008, 09:46 PM
You can use a case saver with the 16T if you grind it down a little bit. I'm running one with a Nac's case saver.
REDRIDDER
06-17-2008, 10:24 PM
Originally posted by NacsMXer
You can use a case saver with the 16T if you grind it down a little bit. I'm running one with a Nac's case saver. aah nice to know...you still can not use the guard though correct?
AnDy7
06-17-2008, 11:52 PM
i have a 15 tooth front and i tried grinding it down as much as i could and it still touched a bit so i just cut it off. I'm putting the old sprocket on and i bought a new case saver i don't want the chain to snap and screw something up.
06-18-2008, 12:20 AM
I run a 16t front with a pro-design case saver and the factory gaurd.
NacsMXer
06-18-2008, 11:08 AM
Originally posted by AnDy7
i have a 15 tooth front and i tried grinding it down as much as i could and it still touched a bit so i just cut it off. I'm putting the old sprocket on and i bought a new case saver i don't want the chain to snap and screw something up.

Probably because yours is a 2007 which comes with a factory 14T front and a smaller case saver designed for it. The aftermarket case saver should be able to accommodate up to a 16T front with some grinding like I am running ;) The 15T should bolt right up with no grinding using the aftermarket case saver.
NacsMXer
06-18-2008, 11:11 AM
Originally posted by REDRIDDER
aah nice to know...you still can not use the guard though correct?

I ditched the guard a long time ago so I wouldn't know....but if Ikilla 2 is running it, then there ya go.
AnDy7
06-18-2008, 12:38 PM
NacsMXer THanks hopefully it works out when i get my case saver this week.
drew416ex
06-18-2008, 04:47 PM
Thats good to know. I have a nacs case saver thats been in a box for years.
blankenship
06-19-2008, 05:20 PM
does the 16t affect wheelies i really want to get a 15t,16t but do not want to loose all my bottom end.....is ther a big dif between stock and 15t,16t......
AnDy7
06-19-2008, 05:22 PM
i can still do some wheelies take a lil more effort. why dont u go bigger on the rear sprocket. three in the back=1 in the front but it will cost u more
drew416ex
06-19-2008, 07:37 PM
Originally posted by AnDy7
i can still do some wheelies take a lil more effort. why dont u go bigger on the rear sprocket. three in the back=1 in the front but it will cost u more

You would actually go smaller in the rear to have the same affect as going up in the front.