What do i do??

[tom416ex]

i took apart my rear end on my 400ex to replace the swingarm. its all apart, i bought a used swingarm. I got all the bolts and crap out except one bearing i cant seem to get out at all. one side came out totally fine, the other one wont move if its like depended on it, my buddy and i tried for over an hour, using liquid wrench, heating the swingarm up and everything, but it just doesnt want to come out! What do you think would be my next step to try to get it out. I was thinking of using a air power tool to try and get it out but kinda scared to, dont wanna ruin anything on the inside..... Any advise would be helpful.......

[jarfly]

If you got a cuttin torch cut it out. I have did this on my rubicon. Just what and dont over cut in the the swinger

[tom416ex]

its the bearing that is inside the swingarm where the pivot bolt goes through.... all other ones are out...