PDA

View Full Version : new start button


DeepC400
06-15-2008, 10:47 PM
I want to remove my stock start button assy. and Intall a single button. What do I do with the idle adj.?
racedad70
06-16-2008, 07:28 AM
Remove it from the throttle body and toss it.You dont need it.
culichi
06-16-2008, 11:26 AM
pics from someone that has remove it
Warnerade
06-16-2008, 10:07 PM
wutcha need a pic for? Just unscrew it at the assy by the fuel pump and put the little rubber boot back on. Get a start button from Cernics, plug and go.
culichi
06-16-2008, 11:36 PM
okay:eek:
Bkillerp
06-17-2008, 12:17 PM
I used a Yamaha dirt bike stop button. I had to hack into the harness, but I was going to hack in and get rid of the clutch sensor and clean it all up anyway. It works great!
DVXracer
06-17-2008, 12:27 PM
Just get the cernics plug'n'go, as for the cold start, unscrew it, put the brass piece and the spring back in and silicone the end of the plastic piece and screw it back on, thats what i did....
rob-u/21
06-17-2008, 01:18 PM
A lot of people use dirtbike buttons but you have to do some wire cutting. I have a Cernics Plug N Go on both of my LT-R's and I really like them cause they plug right in. Yoshimura sells a bolt that you put in place of the idle cable. You can easily make your own but they are $10 so I just got them, plus they look nice.