BansheeShad
06-14-2008, 06:54 PM
2001 4 mill Drag Banshee, 391 on Alcohol. The Banshee was Dynoed right at 100 horse and is ready to race! All motor work was done by F.A.S.T racing:
-Full race port on stock cylinders at 40 over w/coolhead 21cc domes
-Wiseco pistons and crank (fully welded)
-Shearer In-frame Pipes
-+2 forward stock width Metal Tech chromed A-Arms
-Protaper Bars
-JJ and A polished axle (Drag Width)
-+6 chromed drag swingarm
-Wave Rotor
-Polished Stator cover from F.A.S.T. racing
-Polished clutch cover and lock-up clutch w/ see through cover (F.A.S.T. racing)
-Polished Aluminum pegs
-Dyna-Tek ignition
-39 mm Keihin carbs w/ large bowls tuned for alcohol
-TM design chain guides
-Polished gas cap
-Front 300 EX shocks by Superior Shocks
-Rear shock is off a 2004 Yamaha R6
-Stainless Steal Braided rear brake lines w/billet clamps
-Cascade Gear Slammer shifter
-Override Transmission
-Cascade Billet Dipstick
-Chromed Rear brake lever
-rear lower shock link has been lighted and polished
-Magnetic drain plug
-Large orifice fuel drain
-Extended and polished throttle lever
-Polished throttle cover
-Shockpro graphics
-21x12x8 Paddle Brats, 9 paddle on blue label Douglas (rear)
-21x7x10 Skat Trak Mohawk (front)
- Under seat ignition switch
-Nology spark plug wires
-Reed spacers
-Reed cages ported to match cylinders
-Powder coated frame, front hubs, and steering stem
-All nuts, bolts, and brackets are chromed or stainless
The motor was built by F.A.S.T. racing and runs as fast as it looks. For more information about motor work, contact Jeff at F.A.S.T. racing 785.364.5325. Asking $7500.00. Will consider trade for sport bike or counter offer. Please email or respond to posting if you have any questions. The bike is located in D/FW area of Texas. frankiebryson@yahoo.com.
-Full race port on stock cylinders at 40 over w/coolhead 21cc domes
-Wiseco pistons and crank (fully welded)
-Shearer In-frame Pipes
-+2 forward stock width Metal Tech chromed A-Arms
-Protaper Bars
-JJ and A polished axle (Drag Width)
-+6 chromed drag swingarm
-Wave Rotor
-Polished Stator cover from F.A.S.T. racing
-Polished clutch cover and lock-up clutch w/ see through cover (F.A.S.T. racing)
-Polished Aluminum pegs
-Dyna-Tek ignition
-39 mm Keihin carbs w/ large bowls tuned for alcohol
-TM design chain guides
-Polished gas cap
-Front 300 EX shocks by Superior Shocks
-Rear shock is off a 2004 Yamaha R6
-Stainless Steal Braided rear brake lines w/billet clamps
-Cascade Gear Slammer shifter
-Override Transmission
-Cascade Billet Dipstick
-Chromed Rear brake lever
-rear lower shock link has been lighted and polished
-Magnetic drain plug
-Large orifice fuel drain
-Extended and polished throttle lever
-Polished throttle cover
-Shockpro graphics
-21x12x8 Paddle Brats, 9 paddle on blue label Douglas (rear)
-21x7x10 Skat Trak Mohawk (front)
- Under seat ignition switch
-Nology spark plug wires
-Reed spacers
-Reed cages ported to match cylinders
-Powder coated frame, front hubs, and steering stem
-All nuts, bolts, and brackets are chromed or stainless
The motor was built by F.A.S.T. racing and runs as fast as it looks. For more information about motor work, contact Jeff at F.A.S.T. racing 785.364.5325. Asking $7500.00. Will consider trade for sport bike or counter offer. Please email or respond to posting if you have any questions. The bike is located in D/FW area of Texas. frankiebryson@yahoo.com.