Kill switch

[pbr524]

Anyone know what wires to hook a Pro Design kill switch to I 'm not sure f the one I have is a closed or open one

Thanks

I know about the pro armor. Splice the long wire to the black with a yellow stripe wire tht comes out of your CDI box. You can hook the shorter ground wire into a green wire or you can put a connector on it and ground it by putting it on a bolt. The other way to do it is to hook the longer wire up to the black with a white stripe wire coming out of the stock killswitch and once again either grounding into the green wore or putting it around a bolt on your frame.

[MRJACK9]

Connect and Ohmeter across the two leads. If the ohmeter indicates about "zero ohms" the switch is normally closed, if it indicates a high resistance, in excess of 100k ohms then it is normally open. Activate the switch the meter should indicate the opposite of the above.