quadracer99
06-12-2008, 11:02 AM
Okay, so i searched around here and on trx450r.org. I wired the kill switch like the "How To" said on the 450r.org... basically here is my problem... It works backwards, when i have the kill switch un-hooked it starts and when i hook it back up it quits. I have tried several wiring ways and it either doesnt start at all, stays started, or works backwards.
I have been wiring it to the kill button on the handlebars by using the black/white tracer wire and also the green/black dashed wire. i also made the mistake of wiring right to the red wire to the key switch and blew a fuse, then letft the fuse out, hooked it up again, put new fuse in and blew that one ... so now im dead in the water and would like to know how to hook it up correctly.
Its on an '07 450er, i would like to keep the key as much as possible, but if not, would i have to splice in to the black/white traced wire comming from the key switch?
I have been wiring it to the kill button on the handlebars by using the black/white tracer wire and also the green/black dashed wire. i also made the mistake of wiring right to the red wire to the key switch and blew a fuse, then letft the fuse out, hooked it up again, put new fuse in and blew that one ... so now im dead in the water and would like to know how to hook it up correctly.
Its on an '07 450er, i would like to keep the key as much as possible, but if not, would i have to splice in to the black/white traced wire comming from the key switch?