Need a-arm help

[redroost85]

Especially for any 250exers. I am taking my a-arms, upper and lower, off to be powder coated. My trouble is that I have gotten the bolts off of the frame, but I can't figure out how to get it off of the brake assembly. I have already taken off the bolt that had a cotter pin through it too. Do I just keep yanking or is there something I am missing? Any help would be appreciated!

There is a thread in the frequently asked questions forum
that may help ..
BTW,if your not using the ball joints again
you can use an automootive ball joint seperater tool ..cause
this will most likely ruin the boot..