needle jet re-connect help

[seitz729]

I moved the clip position on my needle jet. I am cannot seem to re-connect the slide mechanism back together. I understand what needs to happen. However I cannot seem to align the pieces and spring. I know there is probably a trick to get this back together. It came off very easy. Any help would be greatly appreciated. (2004 400EX, Kehin carb)

[hondaking52]

well i'll try and take a shot at this, i might be wrong, if ur carb is a stock one????, ur probly talkin about the screw you have to take out to get the slide out???, if so, once you have it back together u need a needle or small pin type thing and on the bottom side of the hole you can just see the side of the hole were the screw screw's into, stick the pin in and pull it back over into position and put the screw back in b4 it slides back, hope this helps