linkage? barring

[chases]

are linkage barring press fit???

[j_cyrus3]

I used a hammer and a socket to put mine in. Just make sure you dont hit it so hard you start knocking the needles out.

[chases]

how hard i got them in flush i don dar try to go all the way


any one done this with a yfz450 linkage

[motoboy66]

your better to press them. A hydrolic press is best, but a vise works just as well. Use a socket that fits inside, and a a bigger one to back it up. Put the big one on one side and use the vise to press the bearing through. I use this method when I don't have a hydro press close.

[86 Quad R]

heat the linkage up real good and it will be much easier.