Flyin-Low
05-21-2008, 05:24 PM
Alright so I went out the other day and the good ol' 450 wouldn't start.. Came really close to firing up but just wouldn't do it.
I took the head off and my exhausts were down to .09 and .010.. the left intake was at 0.03 and the other I couldn't get my smallest feeler gauge in!
This is my first time working on valves, other than shimming. So what do you suggest I replace?
The one intake had some burnt oil built up so I figure I need to replace the seals, but should I do all four just in case?
I was thinking Kibble White intakes but not sure if I should replace the exhausts too?
Please help me out, just let me know what to do!!
Thanks.
I took the head off and my exhausts were down to .09 and .010.. the left intake was at 0.03 and the other I couldn't get my smallest feeler gauge in!
This is my first time working on valves, other than shimming. So what do you suggest I replace?
The one intake had some burnt oil built up so I figure I need to replace the seals, but should I do all four just in case?
I was thinking Kibble White intakes but not sure if I should replace the exhausts too?
Please help me out, just let me know what to do!!
Thanks.