powder caoting arams

[cms400ex]

I had my Aarms powder caoted and they lasted two minutes, it seamed like it mess up the ball joint . has anyone tried to powder caot stock aarms ?

[jrafter]

the ball joint arnt replaceable on stock aarms

how did you heat them up with the joints still on

[NacsMXer]

Originally posted by cms400ex
I had my Aarms powder caoted and they lasted two minutes, it seamed like it mess up the ball joint . has anyone tried to powder caot stock aarms ?

It is widely known on here that it is very difficult to PC stock a-arms without ruining the ball joints. The heat will melt the plastic "cup" lining the inside of the ball joint....sounds like you just did the same. I think I heard of one member that actually succeeded, but at low heat in the oven or something like that.

[Honda#4]

I remember that also, but your best bet is to paint them unless you buy arms with removable joints.

[Yellow2004ex400]

I would trash them and get a set of aftermarket a-arms, perferably Roll Design