Rear upper shock mount brace

[dwhst9]

For those of you running a Hetrick pipe on a Scrambler/Predator/Kasea/etc. frame, could somebody please post some pics & measurements of where you located the vertical brace. It's the brace that you welded in that runs from the rear motor mount crossbar up to the shock mount? I don't have a pipe yet and I want to make sure I leave enough room to get the pipe in/out after that brace is welded in place.

[tireman43]

If you weld it about centered between the motor mounts you will be fine. I forgot about leaving room for the pipe when I was doing mine and it worked out just fine. If I remember tonight when I get home, I'll try to find pics.

Kevin

[dericsdad]

I welded ours just a little to the left of center. Plenty of room though.

[dwhst9]

Originally posted by dericsdad
I welded ours just a little to the left of center. Plenty of room though.

As viewed from the back of the frame or the front?

[tireman43]

Here are those pics. The first one is a Predator frame and the second green frame is my daughters DRR. They are the same at the rear.

[tireman43]

Heres the DRR.

[dwhst9]

Thanks for the pics :)

[dwhst9]

I posted pics of the brace I used on my Scrambler 90 build-up thread.