few 400ex parts for sale

[markvette]

i have a few parts left over from our hybrid build. if they dont sell here in a few days they will go on ebay.

clutch side cover $40
flywheel with starter clutch and gear $50
clutch hub, basket and pressure plate, all 3 pieces $75
stator $50
sparks head pipe. will be cleaned and powder coated high temp silver before shipped $75

[sideways]

have any pics of the sparks head pipe? what is the outer diameter? (where the slip-on goes) wondering if it will fit with my fmf

[markvette]

od is 1 3/4" pipe is still dirty as i just dug it out of my storage. like i said i will clean, sand blast and powder coat hi temp silver before it is shipped or you can have it the way it is for $50


http://i114.photobucket.com/albums/n246/quaddad1958/100_2952.jpg

[sideways]

One emore measurement if you will. From the flange (where it meets the head) to the end (where the slip on goes)? if it's somehwere around 21 3/4 or 22 inches, i'll take it.
I'll pay the 75 with it powdercoated. do you have paypal?

[markvette]

ok will get that for you later today. on my way to pick up a new compressor, mine blew the piston. yes i have pay pal.

Mark

[markvette]

ok got it powder coated today and measured it. not sure what the best way was but from the end that bolts to the head to the end of the pipe is 17". if it dont sell here by tomorrow it goes on ebay


http://i114.photobucket.com/albums/n246/quaddad1958/100_2954.jpg

[sideways]

I'm sad to say that wont fit my setup. thanks for all the measurements. it seems its 5 inches to short. guess i have to break down and buy the powerbomb.... thanks again!