PDA

View Full Version : scrambler 500 ball joints



MichiganMOOSE79
05-05-2008, 12:01 AM
buddy of mine has just bought a 2000 scrambler 500, on the inside of the front tires there are wear\ worn through marks on the rims, to the point where its leaking air through, the ball joint seem tight, wheel bearings are good, what is going on\ causing this, the ball joints are whats rubbing, but cant seem to figure out why? any help or suggestions would be great! thanks

stresy01
05-05-2008, 10:54 PM
sounds like a money pit I'll give him $50 for it!!!

MichiganMOOSE79
05-06-2008, 03:31 AM
its 25$ more than i was thinking!

rundrave
05-08-2008, 09:46 AM
the balls joints get worn over time and need to be replaced

there is a little cup in the bottom of the strut that they sit in. There is also a grease zerk right there to keep them lubed up.

if they dont stay greased they get worn down allowing them to travel more. also check your tie rods and that the camber of the front wheel is correct.

tell your friend to check out www.gen3usa.com

that site is all about scramblers, trailblazers and 400 sports.