View Full Version : 250x Gear shifter help
2fastandfurious
11-26-2002, 05:13 PM
The gear shifter that protrudes form the tranny is slipping on the little teeth and not "grabbing. I have tightened the nut and bolt all the way, still no good! Any suggestions?
Thanks!
Ben
KP's lil'300
11-26-2002, 05:20 PM
are the little teeth broke off? or is it just not grabbing? KP
2fastandfurious
11-26-2002, 05:32 PM
the teeth are still no the shaft that sticks out. Are there teeth on the gear shifter clamp?
jerry-89-250R
11-26-2002, 05:39 PM
yes
2fastandfurious
11-26-2002, 05:51 PM
Where can i buy one at? Any after market ones?
-Ben
honda250xrider
11-26-2002, 06:00 PM
try buying a new bolt i tightend my bolt to tight before and it striped and all i needed was a new bolt try that before buying a new gear shifter
jerry-89-250R
11-26-2002, 06:01 PM
sure are aftermarket shifters, any salvage yards near you or honda dealers
2fastandfurious
11-26-2002, 10:46 PM
Thanks guys. Problem fixed. Bolt was stripped AND broke. no wonder it was so lose!!!!!! Replacing wiht stainless steel hardware tommrow!
-Ben
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.