fullbore or laker custome poll and post pics

[big400boy]

orange frame. need plastics fullbore of laker custom? race cut. post ur pics and vote.

[400ex28]

both plastics look great but i'm gonna have to go with Laker cause I got em'.

http://i18.photobucket.com/albums/b132/TCracin416ex/HPIM5140.jpg
http://i18.photobucket.com/albums/b132/TCracin416ex/HPIM4032.jpg

[coryatver]

Is the seat on right it looks like where the front and rear fenders meet it doesn't fit up very good

[big400boy]

nice bike one question, whats up with the overlap between the front and rear plastics?

[400ex28]

Originally posted by coryatver
Is the seat on right it looks like where the front and rear fenders meet it doesn't fit up very good

Most aftermarket fenders are like this, but I also dont have the 2 bolts for the lower mounts. I lost them so right now its just zip tied on so that prob has to do with some of that.

[400ex28]

Originally posted by big400boy
nice bike one question, whats up with the overlap between the front and rear plastics?

I'm pretty sure all Lakers are like that on the 400ex's but it's not bad at all. Dosn't bother me at all.

[TRXRacer1]

My Maiers looked like that until I adjusted them. You can make the Lakers looks better too with some work.

[2001400ex]

Originally posted by TRXRacer1
My Maiers looked like that until I adjusted them. You can make the Lakers looks better too with some work.

Can you post pictures of your Maiers? I am thinking about getting a set of front race cut Maiers and their replacement rear fenders.

[TRXRacer1]

Originally posted by 2001400ex
Can you post pictures of your Maiers? I am thinking about getting a set of front race cut Maiers and their replacement rear fenders. No problem but you'll have to check back tomorrow. I'll take some new pics since I adjusted the plastic and installed a new seat cover.

[2001400ex]

Originally posted by TRXRacer1
No problem but you'll have to check back tomorrow. I'll take some new pics since I adjusted the plastic and installed a new seat cover.

Awesome, I can't wait! What did you do to "adjust" your Maiers? This way I know what to do if/when I decide to get them. I was going to go Fullbores but they aren't very cheap, so now I'm thinking Maiers.

[TRXRacer1]

First of all I just noticed that I didn't have the seat locked into the tank when I took the pics......sorry about that.

For fitment you just have to move them around until they line up correctly. I use those Honda body bolts with the large collar built into them when I change something. They require a much larger hole in the plastic allowing you to work right over existing smaller holes and they keep you from smashing the plastic when you tighten them. I know it's not perfect but it's a LOT better then what it was. On the right side I even had to space out the front fender where it meets the rear about 10mm. You just do what ever it takes really.

http://miltechsolutions.tripod.com/offroad/wata/400ex/bodylineleft.jpg
http://miltechsolutions.tripod.com/offroad/wata/400ex/bodylineright.jpg

[2001400ex]

Looks good! Thanks for replying.:)

[riderssb250x]

hers my 440ex