Graphics HELP - Will not stick

[lawdog800]

I put on the new graphics today after cleaning the new plastics. On every edge where the graphics bend a little to follow the contour, they are lifting and coming off...bad. 1 piece almost fell completely off. I tried warming the garage, warming the graphics, everything, but still come right back up..
Any ideas or suggestions....

I DID NOT do the water install method either, put them on dry.

[hornetgod13]

I wiped my plastics with alcohol wipes first and used a hair dryer.

X2

Get the graphics so hot the glue is almost melting and they will stick no problems.

[BigBore24]

do you heat the graphics before or after you put them on?

[Mercedes]

wipe plastics clean with alcool the spray plastics with soapy water then apply graphics and place as you wish. then just use a heat gun or blow drier and pull water out from under with a credit card, or something like that . and just keep on heating up the graphics until there is no water left under

[eastcoastpro20]

leave the bike in a heated garage overnight, to let the glue sit

[Benjithx]

hair dryer