needed longer cylinder base studs

[pimpt250r]

any 1 got a pair ,or know where to get a set if you have a pair and wanna part with let me know ,

paypal ready

need them yesterday

[kit bazile]

how long you need them i have 2 sets

[pimpt250r]

4.5mm longer than the stock 87-89(10x45)I sold the ones I need 10x55 (97 cr250) with my old lower by mistake ,the guy I bought my new lower from ran a spacer plate but apparently it was a small spacer plate because they didnt even come close to working

not sure if my numbers are exact but there for my PC2000 cylinder

[mxduner]

i need a set also, for a 310 pv with a spacer plate on a 88 bottom end (long rod)

[pimpt250r]

I just bought 2 10x55 cr studs off bikebandit Im not sure if they will be long enough but they were only like 4 on the pair I needed a couple of other little things so I just said screw it I hope they work though

[bushwesl]

You'll have to keep us all posted on how well they worked out. And then provide us all with the part # ;)

[pimpt250r]

10x55 part number 246306-001

10x80 part number 246180-001

not sure if there honda numbers ,but its the numbers off bikebandit

[morse250r]

honda part number 92900-100550B
just got these last week from esr over priced once i looked up on a honda site 1.50 ish good luck