View Full Version : Help! Valve Clearance for a Stage 2 hot cam
Sandman69
04-09-2008, 08:56 PM
I know the stock clearance is .005 on the exhaust valves and .004 on the intake but does anyone know the clearance for a Stage 2 hot cam? I can't seem to find it anywhere. I have found some for the Stage 1 but that is it.
Anyone??
lghickman21
04-09-2008, 09:09 PM
you should use the same clearance
Sandman69
04-09-2008, 09:41 PM
Hotcams have different vavle gap clearance requirements than stock.
I know the Stage 1 is .005 and .006
blue_ex_rider
04-09-2008, 09:46 PM
Originally posted by Sandman69
Hotcams have different vavle gap clearance requirements than stock.
I know the Stage 1 is .005 and .006
.005 and .006 is what you want to set them at.
Sandman69
04-09-2008, 09:56 PM
Originally posted by blue_ex_rider
.005 and .006 is what you want to set them at.
Then that is what I will do...
Thanks
Honda#4
04-10-2008, 07:08 AM
Here the specs
brokenmike
04-10-2008, 08:12 AM
I hate to throw a wrench in the works but which stage 2 hotcam do you have? The old one uses .006 in and .008 ex. The new one uses .005 in and .006 ex
http://www.supermotors.net/getfile/624436/fullsize/scan0005.jpg
Sandman69
04-10-2008, 09:07 AM
Originally posted by brokenmike
I hate to throw a wrench in the works but which stage 2 hotcam do you have? The old one uses .006 in and .008 ex. The new one uses .005 in and .006 ex
http://www.supermotors.net/getfile/624436/fullsize/scan0005.jpg
The cam is only 2 years old. I would say it is new. I appreciate all the advise everyone and will start at .005 and .006.
REDRIDDER
04-10-2008, 10:52 AM
this one is a stage 1 i bought about 5 years ago.
440exadee
04-10-2008, 11:19 AM
according to their website all three are the same valve clearance even my stage 3 is intake .005 exhaust .006
Powered by vBulletin® Version 4.2.1 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.