A Arm Bushings

[frank_claytor]

CAN U PRESS BUSHINGS OUT OF THE A ARMS AND NSTALL THEM N ANOTHER SET WITHOUT DAMAGING THE BUSHINGS IF SO HOW THANKS

[fastredrider44]

Yes, but don't go pressing them. They have retaining clips on both sides of the bushing. Pop the seals out on both sides, pull the clips out on both sides, and take a socket and GENTLY tap the bushing out with a hammer. It takes some time an patience on those clips. The bushings are like miniture ball joints so be sure to repack them with grease before you install them.

[frank_claytor]

WOULD LONESTAR BUSHINGS B THE SAME AS FACTORY BUSHINGS

[fastredrider44]

Don't know, If you want stock replacements, get a set of pivot works. I've had good luck from them.

[frank_claytor]

iv got lonestar arms and a couple of the bushings r bad also got a set of factory arms with good bushings but bad joints can i take the stock bushings and put them in the lonestar arms

[the Z Man]

LoneStar is different, they take sleeves with moly plastic....

[frank_claytor]

were is the fastes and cheapst place to get a arm bushings for a set of jd perfomance a arms thoght iwas gettn lonestars but there jds

[the Z Man]

What do they look like? (bushings) pic..

[frank_claytor]

cant load up picture u can look at them on jdperformanceatv.com if u would like

[the Z Man]

Looks like LoneStar will work..