cuatrofreak
03-27-2008, 06:51 PM
I have a 1987 250x and was unaware of the smaller bolt pattern on the front hubs until I purchased new wheels and tires off of a 400ex and they wouldn't fit.
If I were to purchase 300ex front hubs with the larger bolt pattern would I run into a problem with the new hubs going onto the stock 250x spindles?
Does anyone know if the bearing races are the same?
Has anyone tried this swap before?
I also was wondering if it would be possible to swap over to dual piston "R" pieces?
Anyone want to get rid of some stock 250r hub, rotor, and caliper assemblies?
If I were to purchase 300ex front hubs with the larger bolt pattern would I run into a problem with the new hubs going onto the stock 250x spindles?
Does anyone know if the bearing races are the same?
Has anyone tried this swap before?
I also was wondering if it would be possible to swap over to dual piston "R" pieces?
Anyone want to get rid of some stock 250r hub, rotor, and caliper assemblies?