PDA

View Full Version : Reverse Light Blinking



badquad
03-25-2008, 12:26 PM
Hey My dad has a 2007 Grizzly 450 and once in a while on start up the Reverse Light will start blinking. It does not happen all the time.

I looked in the manual, and I am not sure if it said to call the dealer on a speed sensor. It also said if the speed-o was not working right. But my dad's speed-o is working OK.

We can't take it in because of our location. We would have to fix it our selves.

Any suggestions?

TOPDAWG
03-25-2008, 05:48 PM
Check wire connections and put dielectric grease in them. As a matter of fact, grease every plug you can find on the quad including your spark plug boot. Also, check the bulb to see if it is loose and grease that too.

Deez
03-28-2008, 03:35 PM
mine will flash when I get the wiring under the seat around the starter silonold soaked. Just to give you a idea where to look.

badquad
03-31-2008, 05:23 PM
Thanks.. I will look into it. I did notice that the winch ground wire broke off. When I went to go clean the air filter. Thanks. again.