PDA

View Full Version : Kasea 70 help



03bill
03-21-2008, 04:23 PM
I have been working on these for a long time but I recently been having trouble with the arsinal 70 kit I put on one of my bikes. I blew a head gasket and changed it out. It ran good for about 2 rides and now it will not idle and is very hard to start. I do not have a spare head but I am thinking the head is warped. Has anyone else had this problem?

jandjracing
03-22-2008, 08:49 AM
Sounds like crank seals or engine case half seal. Spray some carb cleaner at these areas when it is running and see if it changes anything.

03bill
03-26-2008, 02:06 PM
I pulled the motor from the bike and checked the head and piston. The ring was seized and caused a burn mark across the cylinder. I ordered a new one and I will install it and see if this fixes the problem.