PDA

View Full Version : 400ex has no power



400exkid2
03-20-2008, 07:48 PM
one of my 400ex has a problem the engine doesnt seem to run right. it will start but it has no power when u get going we thought it was the carb, we cleaned it and it didnt help. if you have any idea please help

Brauap
03-20-2008, 07:55 PM
This may seem dumb, so dont get offended, is the choke on? That'll do that. Does is have a full tank of gas? or is it low and its starving for gas?

honda300EXtreme
03-20-2008, 08:11 PM
what year is the quad?
does it smoke?
did it just loose power out of no where, or did you change or replace something that could of done this,

give some info so we can help you out

400exkid2
03-20-2008, 08:25 PM
no the choke isnt on an it has a full tank

i was riding the quad on my track and i took an corner and it felt like the quad was low on gas so i went and put gas in it and that didnt help it just quit out of no where

400exkid2
03-20-2008, 08:26 PM
and it is a 99 an it doesnt smoke

honda300EXtreme
03-20-2008, 08:33 PM
if it happened clear out of no where like that,

it seems to me like its a fuel related problem, i would re-clean the carb, drop the bowl and take out the jets, and clean everything,

also check the vent on the carb and the vent on the gas tank,,

400exkid2
03-20-2008, 08:38 PM
k thanks i have an 02 400ex and that runs great
i just ask cuz im gettin ready to sell an i need to get that fixed

buster024
03-20-2008, 09:45 PM
honda300 had it right. I'd check the gas cap. Does it run good for a few minutes, then suffer? If so, there may be something clogging the air relief tube.

fast2007
03-21-2008, 07:33 AM
Check the valve lash..

gcart2
03-21-2008, 07:34 AM
lol is it blown up?

400exkid2
03-21-2008, 02:15 PM
no it isnt blown up
would it run if it was blown up

2muchquad
03-22-2008, 11:04 PM
Make sure the 2 small screw the hold the needle retainer in the slide didnt come loose.It will only cough and hiccup with anything more than a quarter throttle.i have personally seen this happen.Guy was trying different needles and positions etc and must not have tightened them snug in the heat of the moment,it happens.