Metzroth
03-16-2008, 11:50 PM
Right now I am hurting pretty bad for money. I think if i sell either one of my motors I should be ok. I have a completely stock 400ex motor (which is currently on my quad) that I would be willing to sell. I also have a motor that I should be finishing up the build on soon that will be a strong running motor. Bottom end is all stock.
....J.E. 10.8:1 comp piston 87mm (416cc).
....Using silicone sealer instead of base gasket to raise the compression a bit more.
....Thin head gasket to again raise comp. ratio.
....Kibblewhite valves.
....Kibblewhite Titanium valvesprings and retainers.
....Head has fresh 3 angle valve job.
....Cylinder was bored to match the J.E. piston.
....New HD Cam Chain.
....New Cam Chain Tensioner.
....New Valve Seals.
....Hot Cam Stage 1.
All parts were reccomended by and purchased from C&D Racing.
If intersted in either motor, PM me with an offer. I also have a set of A-Arms that are powder coated blue, a stock frame, an extra stock carb, a swinger skid, and lots of other parts. If you need something, let me know and I might have it laying around. Thanks!
....J.E. 10.8:1 comp piston 87mm (416cc).
....Using silicone sealer instead of base gasket to raise the compression a bit more.
....Thin head gasket to again raise comp. ratio.
....Kibblewhite valves.
....Kibblewhite Titanium valvesprings and retainers.
....Head has fresh 3 angle valve job.
....Cylinder was bored to match the J.E. piston.
....New HD Cam Chain.
....New Cam Chain Tensioner.
....New Valve Seals.
....Hot Cam Stage 1.
All parts were reccomended by and purchased from C&D Racing.
If intersted in either motor, PM me with an offer. I also have a set of A-Arms that are powder coated blue, a stock frame, an extra stock carb, a swinger skid, and lots of other parts. If you need something, let me know and I might have it laying around. Thanks!