Log in

View Full Version : front sprocket install


STUNTIN400EX
03-09-2008, 08:39 PM
do i need to remove tne chain or can i just loosen it up and remove the front sprocket and install the new one?
04TRX400EX
03-09-2008, 08:53 PM
No, you do not need to remove the chain. Like you said, just loosen it up and you should be able to remove it no problem.
STUNTIN400EX
03-10-2008, 05:48 PM
IF I GO FROM A 15 TO A 13 TOOTH SPROCKET WILL I HAVE 2 GET A NEW CHAIN?
REDRIDDER
03-11-2008, 11:41 AM
pretty sure their will be enough adjustment on your carrier that you'll be fine.I just bought a 13 tooth sprocket to play around with but i haven't installed it yet.I bought a primary drive front 13 tooth sprocket and it came with 2 clips has anyone seen this before?
STUNTIN400EX
03-11-2008, 01:21 PM
MINE HAS CAME WITH ONE CLIP. MIGHT HAVE BEEN A SCREW UP. THANKS FOR THE HELP.
TRXRacer1
03-11-2008, 05:22 PM
You're only supposed to get 1 clip. 2 must have been a screw-up.
STUNTIN400EX
03-11-2008, 05:41 PM
HOW MUCH WOULD I LOSE IN TOP END WITH A 13T? I KNOW IT WILL BE QUITE A BIT BUT, 10 MPH SEEM REASONABLE OR COULD IT BE MORE.
TRXRacer1
03-11-2008, 06:20 PM
Originally posted by STUNTIN400EX
HOW MUCH WOULD I LOSE IN TOP END WITH A 13T? I KNOW IT WILL BE QUITE A BIT BUT, 10 MPH SEEM REASONABLE OR COULD IT BE MORE. I think 10 would be dead on if you haven't changed tire sizes too.
JOEX
03-11-2008, 06:25 PM
This may not work for the newer model 400ex's....

http://home.earthlink.net/~gellett/400ex.htm
STUNTIN400EX
03-11-2008, 10:01 PM
thanks for all the help! i went ahead and bought a 14t then if the 13t is terrible i can just change them out.