Dougy_Fresh22
03-07-2008, 03:46 PM
I recently picked up a trx that needed some work. All the gas was terrible so I ripped the carb apart to clean it and these were the jetting settings.
160/42 4th clip position. Mods that I know of are a ESR pipe and silencer, K&N airfilter with no air box lid, and a coolhead. Wondering if that seems in the ball park at all?
Thanks
Doug
P.S The machine seems to run pretty well I haven't driven it much since it has been really cold and the front end needing some attention. But it will not idle, I had it idling for 5-10 mins then took a slow put around the yard and then wouldn't idle again. Went out this morning 10 degrees out and it surprisingly started on one kick but would not idle unless you keep your thumb just barely touching the throttle.
160/42 4th clip position. Mods that I know of are a ESR pipe and silencer, K&N airfilter with no air box lid, and a coolhead. Wondering if that seems in the ball park at all?
Thanks
Doug
P.S The machine seems to run pretty well I haven't driven it much since it has been really cold and the front end needing some attention. But it will not idle, I had it idling for 5-10 mins then took a slow put around the yard and then wouldn't idle again. Went out this morning 10 degrees out and it surprisingly started on one kick but would not idle unless you keep your thumb just barely touching the throttle.