Danky_wet
03-05-2008, 02:04 PM
RACE READY HONDA 250R:
Ac Pro Peg Nerf Bars
Ac Grab bar and Stadium Front bumper
Tag quad bend bars
Pro Design tether
Pep EZ-pull clutch lever
Lonestar +2 +1 A-arms
Elka Triple Rate w/remote rezzys
Lonestar Axle/stock hubs
Lonestar bearing carrier
Rpm -1 Swingarm
Rear Stock shock reworked into a dual rate
Twin Air/38mm Pwk (carb is new)
V-force 2 reeds (petals new)
Ported Cylinder w/60. over Wiseco Prolite (recently checked compression at 225 lbs. , piston has 3-4 hours on it)
Runs on Race Gas Only (110) Could be modified to run Pump Gas.
Paul Turner Pipe High Rev
Fat Boy 2 silencer (recently repacked)
Maier Race Plastics (nice shape, small burn near silencer)
Nac's Number plates
One Industries seat cover(2 small holes, otherwise nice shape)
Clarke gas tank
Front and Rear Beadlock rims
Holeshot MX fronts/Turf Tamer rears)
Rear Wave Rotor
Steel braided brake lines front and rear
It also has 4 new Ball joints.
Nac's case saver and parking brake
block-off.
PowerMadd hand gaurds
K&N Air Filter Dual Stage
Asking $3000.0 or B.O. or will consider trades.
I prolly forgot a couple things on the quad but If I remember anything else I will add to post.
Click Here For Pictures >>>
http://community.webshots.com/album/562212639OHuePC
Thanks for looking!
My email is Ez2tez@hotmail.com
Would really like to trade for an 250 4-stroke bike. Will throw cash if needed.
Ac Pro Peg Nerf Bars
Ac Grab bar and Stadium Front bumper
Tag quad bend bars
Pro Design tether
Pep EZ-pull clutch lever
Lonestar +2 +1 A-arms
Elka Triple Rate w/remote rezzys
Lonestar Axle/stock hubs
Lonestar bearing carrier
Rpm -1 Swingarm
Rear Stock shock reworked into a dual rate
Twin Air/38mm Pwk (carb is new)
V-force 2 reeds (petals new)
Ported Cylinder w/60. over Wiseco Prolite (recently checked compression at 225 lbs. , piston has 3-4 hours on it)
Runs on Race Gas Only (110) Could be modified to run Pump Gas.
Paul Turner Pipe High Rev
Fat Boy 2 silencer (recently repacked)
Maier Race Plastics (nice shape, small burn near silencer)
Nac's Number plates
One Industries seat cover(2 small holes, otherwise nice shape)
Clarke gas tank
Front and Rear Beadlock rims
Holeshot MX fronts/Turf Tamer rears)
Rear Wave Rotor
Steel braided brake lines front and rear
It also has 4 new Ball joints.
Nac's case saver and parking brake
block-off.
PowerMadd hand gaurds
K&N Air Filter Dual Stage
Asking $3000.0 or B.O. or will consider trades.
I prolly forgot a couple things on the quad but If I remember anything else I will add to post.
Click Here For Pictures >>>
http://community.webshots.com/album/562212639OHuePC
Thanks for looking!
My email is Ez2tez@hotmail.com
Would really like to trade for an 250 4-stroke bike. Will throw cash if needed.