07trx400ex
03-04-2008, 07:37 PM
Pro Design K&N Pro Flow Air Filter/ and K&N Power Lid.
(includes outer-wears over filter)
Is anyone running this setup as well as a full after-market exhaust?
Does anyone have any of the individual components?
I am especially curious about the K&N Powerlid. It looks like it would be ok with the dust, but not good with mud. If anyone has used the power lid in muddy conditions please tell me how it does.
Does anyone use the Pro Design Billet Base from the Pro Design Filter Kit? It seems like it would open the plumbing up, but would it let too much dust and dirt in?
This would probably be run with a Yoshi rs-3 full system, and it will all be installed at the same time so I only have to jet once (being very optimistic about that). It should feel like a whole new bike from what I have heard.
(includes outer-wears over filter)
Is anyone running this setup as well as a full after-market exhaust?
Does anyone have any of the individual components?
I am especially curious about the K&N Powerlid. It looks like it would be ok with the dust, but not good with mud. If anyone has used the power lid in muddy conditions please tell me how it does.
Does anyone use the Pro Design Billet Base from the Pro Design Filter Kit? It seems like it would open the plumbing up, but would it let too much dust and dirt in?
This would probably be run with a Yoshi rs-3 full system, and it will all be installed at the same time so I only have to jet once (being very optimistic about that). It should feel like a whole new bike from what I have heard.