guinness77
02-29-2008, 11:20 PM
Question for you guys on some gaskets. While taking apart a 402ex engine (10:1 piston), I discovered some of the gaskets were metal. This was something of a surprise.
Q1. The gasket between the valve cover and head. Is it re-usable? It sure doesn't look like a crush gasket. Would a synthetic gasket from Moose Works do the job?
Q2. The gasket between the head and the cylinder. It's a 2-piece job. Is it re-usable? (I'm thinking "nope" here.) Would a synthetic gasket from Moose Works do the job?
Q3. The gasket between the cylinder and the case. Is it re-usable? Would a synthetic gasket from Moose Works do the job?
Thanks for your imput.
Q1. The gasket between the valve cover and head. Is it re-usable? It sure doesn't look like a crush gasket. Would a synthetic gasket from Moose Works do the job?
Q2. The gasket between the head and the cylinder. It's a 2-piece job. Is it re-usable? (I'm thinking "nope" here.) Would a synthetic gasket from Moose Works do the job?
Q3. The gasket between the cylinder and the case. Is it re-usable? Would a synthetic gasket from Moose Works do the job?
Thanks for your imput.